TA Technix wishbone set front axle with PU bushings
consists of:
2 x TA Technix wishbones (without joint, with rubber bearing)
OEM-comparison number: 191 407 153 A, 191 407 151 B, 191 407 153
2 x TA Technix suspension joint
OEM-comparison number: 357407365, 357407365A
1 set TA Technix PU bushings rear wishbone mount
OEM-comparison number: 191407181D, 191407181E, 357407181
replaces the standard rubber bearing
Fitting location: front - rear
1 set TA Technix PU bushings front inner wishbone mount
OEM-comparison number: 191407182, 357407182
replaces the standard rubber bearing / - metal bearing
Models with sheet steel wishbones
TA Technix tie rod end front axle left side
OEM comparison number: 191 419 811, 3A0 422 811
TA Technix tie rod end front axle right side
OEM comparison number: 191 419 812, 3A0 422 812
2 x TA Technix coupling rod front axle on both sides at stabilizer bar outside "short".
OEM-comparison number: 191 411 315 B, 191 411 315, 191 411 315 BS, 191 411 315 B S1
1 set TA Technix PU bushings assembly / - mounting kit for coupling rod / stabiliser bar support
between wishbone and stabiliser
Inner diameter: 10mm
1 set TA Technix PU bushings front axle - stabiliser outer / - mounting point on coupling rod
replaces the standard rubber bearing in the upper part of the coupling rod
for models with Ø 18mm stabiliser
suitable for:
only models with power steering
Seat Ibiza II Type 6K,
Seat Cordoba type 6K
up to chassis number: 6K-ZR036 750
Seat Toledo I (1L)
up to chassis number: 1L-ZD307 000
VW Golf II incl. Syncro type 19E,19-299,
VW Jetta II type 19E, 19E-299
